Paraview
From HPC users
Revision as of 13:58, 6 June 2017 by JBrunken (talk | contribs) (→Using paraview on the HPC cluster)
Introduction
Installed version
There are currently two version of paraview installed:
- 5.1.2-goolf-5.2.01-mpi
- 5.1.2-intel-2016b-mpi
Using paraview on the HPC cluster
If you want to use paraview on the HPC cluster, you will have to load its correspoding module first. You can do that by using the following command:
module load ParaView
This commands loads a paraview version that was installed with the intel-toolchain. If you need a specific version of paraview, you can specify that by adding the version:
module load paraview/5.1.2-goolf-5.2.01-mpi
This will load the version of ParaView that is installed with the goolf-toolchain.
Documentation
The documentation of paraview can be found here.
